Isipool Programming; Description Of The Frontal Panel; Stand By/Work Of Isipool - Aqua Isipool Rx L3 Manual De Instalacion Y Uso

3.0 Isipool programming

3.1 Description of the frontal panel

3
.2 Isipool stand by/ work
Stand by:
Push the Down button till the display is switched off (about 5 seconds). Only the red point
"pausa" blinks showing that the pump is powered but in stand by state.
12/05/2010
If the light is:
Fixed green, the Rx is correct
Blinking green, the pump is dosing
Fixed red, the pump is in calibration mode
Blinking red, there is an error
The display shows:
The Rx value in mV
The state of the calibration
The alarms
Shows if the filtration is active or not:
The red point is blinking = the filtration is not active
The red point is not lit up = the filtration is active
Increase the desired mV value (with the SET button)
Increase the alarm window (with the SET button)
Decrease the desired mV value (with the SET button)
Decrease the alarm window (with the SET button)
Put in stand by / work the Isipool
Allows to show the set point
Allows to change the set point
Allows to change the alarm window value
Allows to do the calibration of the probe
17