Descargar Imprimir esta página

KENMORE ELITE 146. 33577410 Manual De Uso página 36

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
- Electronic
Ignition
SECTION I
No sparks appear at
any electrodes when
control knob turned
to HI: no noise can
be heard from spark
module.
• Battery not installed
properly.
• Dead battery.
• Button assembly not
installed properly.
• Faulty spark module.
• Check battery orientation.
• Has battery been used
previously?
• Check to insure threads are
properly engaged. Button
should travel up and down
without binding.
• If no sparks are generated
with new battery and good
wire connections, module is
faulty.
• Install battery
(make sure that "+" and "-"
connectors
are oriented correctly,
with "+" end
up and _'-_'end down.)
• Replace battery with new AA-size alkaline
battery.
• Unscrew
button
cap assembly and reinstall,
making sure threads are aligned and engaged
fully.
• Replace spark module assembly.
SECTION II
• Output lead
• Are output connections
• Remove and reconnect all output
No sparks appear at
connections not
on and tight?
connections at module and electrodes.
any electrodes when
connected.
control knob turned
to HI; noise can be
heard from spark
module.
SECTION III
Sparks are present
but not at all
electrodes and/or
not at full strength
• Output lead
connections not
connected.
• Eiectricai arc
between output wires
and grill frame.
• Weak battery.
• Electrodes are wet.
• Eiectrode(s)
cracked
or broken; sparks
appear where
cracked.
• Are output connections on
and tight?
• If possible, observe grill in
dark location. Operate
ignition system and look for
arcing between output
wires and grill frame.
• All sparks present but
weak or at slow rate.
• Has moisture accumulated
on electrode
and/or in
burner ports?
• Inspect electrodes for
cracks.
• Remove and reconnect all output connections
at module and electrodes.
• If sparks are observed other than from
burner(s), wire insulation may be damaged.
Replace wires.
• Replace battery with a new AA-size alkaline
battery.
• Use paper
towel
to remove
moisture.
• Replace cracked or broken electrodes.
36 " 33577-41500319

Publicidad

loading

Este manual también es adecuado para:

146. 33578410146. 33579410