Beta 1871M Instrucciones página 38

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 76
PROBLEMS?
PROBLEMS
- - - - - - - - - - - - - - - - - - -
• The appliance fails to
start.
- - - - - - - - - - - - - - - - - - -
• Reduced efficiency.
- - - - - - - - - - - - - - - - - - -
• The appliance does not
start when in "electric
and pneumatic tools
users" operation.
- - - - - - - - - - - - - - - - - - -
• The motor rate
increases to a notable
extent.
- - - - - - - - - - - - - - - - - - -
Do not dispose of electric tools with household waste!
In compliance with European Directive 2012/19/EU on waste electrical and electronic
equipment (WEEE) and its implementation in accordance with national law, electric
tools that have reached the end of their lifecycle must be collected separately and
returned to an environmentally compatible recycling facility.
38
CAUSES
- - - - - - - - - - - - - - - - - - - - -
• No power.
• Defective power cord, switch
or motor.
- - - - - - - - - - - - - - - - - - - - -
• Drum container full.
• Filter element is dirty or
caked.
• Clogged tubes or accessories.
- - - - - - - - - - - - - - - - - - - - - -
• Detective electronic card.
• Insufficient compressed air
supply.
• Electric tool power is less
than 150W.
• The mail connector to the
compressor is made from
unsuitable material.
- - - - - - - - - - - - - - - - - - - - - -
• Drum container full.
• Filter element is dirty or
caked.
• Clogged tubes or accessories.
- - - - - - - - - - - - - - - - - - - - - -
For EU countries only
SOLUTIONS
- - - - - - - - - - - - - - - - - - - - -
• Check the socket.
• C o n t a c t t h e t e c h n i c a l
assistance centre.
- - - - - - - - - - - - - - - - - - - - -
• Empty the drum container.
• Clean or replace the filter
element.
• Check the swivel hose or
accessories.
- - - - - - - - - - - - - - - - - - - - -
• C o n t a c t t h e t e c h n i c a l
assistance centre.
• I n c r e a s e t h e p r e s s u r e
(>3bar).
• Connect electric tools of a
higher power (MAX 2000 W)
• Replace the connector, which
must be made out of non-
magnetic material (for example:
A2, brass, plastic, etc.)
- - - - - - - - - - - - - - - - - - - - -
• Check the drum container.
• Clean or replace the filter
element.
• Check the swivel hose or
accessories.
- - - - - - - - - - - - - - - - - - - - -

Publicidad

Tabla de contenido
loading

Tabla de contenido