Descargar Imprimir esta página

Setup; Operation - Chattanooga SS Manual Del Usuario

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51

SETUP

Remove all of the contents inside the Hydrocollator Heating Unit and then replace the
wire rack. Make certain the drain valve is closed before filling the tank with water. The
tank should be approximately 3/4 full with packs removed. The tank may be filled from
any standard type faucet.
Check the voltage rating on the serial decal plate which is located on the back of the unit.
To turn the unit on, simply plug the unit into a 120 Volt, 60 Hz or 220/240 Volt, 50-60 Hz
outlet as indicated on the decal plate. To turn the unit off, simply unplug from outlet. Do
not attempt to use direct current. Follow the procedures indicated in the Precautionary
Instructions. Do not attempt to use the unit if it is not properly grounded.

OPERATION

The Hydrocollator Heating Unit is simple and easy to operate. The controls are located
in the rear, near the bottom of the unit. The thermostat controls the temperature of the
water. It is located near the bottom of the unit on the control panel. It has been tested
and preset at the factory to normal operating temperature. If further adjustment is
necessary, it can be easily accomplished by turning the adjusting screw located on the
thermostat. Turning the outer screw counterclockwise lowers the temperature, while
turning it clockwise raises it.
NOTE: Do not turn the inner stem under any circumstance! Stem is preset by the
manufacturer.
The Hydrocollator Heating Units operate through the use of a hydraulic capillary-type
thermostat and can be left plugged in and turned on to provide a ready supply of heated
HotPacs.
The HotPac rack accommodates different sizes and types of packs.
SS-2 Unit – The unit comes complete with eight standard HotPacs.
M-2 and M-4 Units - The M-2 unit comes complete with 12 standard HotPacs. The M-4
comes complete with 24 standard HotPacs.
SS Unit – Holds eight Standard Size packs. Special rack holds two Neck Contour packs.
E-2 Unit – The E-2 unit comes complete with two Oversize, three Standard Size packs and
one Neck Contour pack.
E-1 Unit – With the insert in, the rack accommodates four Standard Size packs.
11
Hydrocollator ® Heating Units

Hide quick links:

Publicidad

Solución de problemas

loading

Productos relacionados para Chattanooga SS

Este manual también es adecuado para:

E-1E-2M-2Ss-2M-4