Calls.to.users.by.selecting.the.code; Direct.call.to.concierge.switchboard; Door Opener Codes - Urmet BiBus sinthesi s2 Manual De Instrucciones

Press. . to. interrupt. the. call. to. the. previously.
selected.user..
The following message will appear on the display if
the.user.lifts.the.handset:.
PLEASE
Press. to end the conversation with the user.
The following message will appear if the user does
not answer within the programmed off-hook stand-
by.time:.
does.not.reply
CALLS TO USERS BY SELECTING THE CODE
Select.NAME
with
Dial. the. code. of. the. user. to. be. called. (numeric. or.
alphanumeric with optional keyboard). The following
will appear on the display:
CALL.TO:
n°1001
Select. the. code. and. press.
user. The apartment door phone will ring for
approximately.3.seconds..Hold.
up.to.three.consecutive.calls..
IN.COURSE
Press. . to. interrupt. the. call. to. the. previously.
selected.user..
The following message will appear on the display if
the.user.lifts.the.handset:.
PLEASE
DS107-035
TALK
User
or.
↑ ↓
. to. call. the. selected.
.pressed.to.send.
CALL
TALK
Press. to end the conversation with the user.
The following message will appear is the user does
not answer within the programmed off-hook stand-
by.time:.
does.not.reply
.
DIRECT CALL TO CONCIERGE SWITCHBOARD
Press. . on. a. call. module. installed. in. a. system.
with concierge switchboard to call it directly. This
is only possible when the concierge switchboard
is in day mode, i.e. when the concierge service is
operative.and.the.function.has.been.activated.(see.
"Programming")..
The following message will appear on the display:
CALL.TO:
Switchboard
The following will appear on the display if the button
A is pressed and either the concierge switchboard
is.in.night.mode.or.the.function.has.not.be.activated.
(see."Programming")..
CODE.NOT
VALID

DOOR OPENER CODES

Press. the. . button. before. entering. each. door.
opener.code..Symbol."∗" will appear on the display
when entering the code for each button. The module
will open the door if the code is valid. A warning will
be.output.if.the.code.is.not.valid..The.sequence.is.
the.same.for."Generic".and."Personal".door.opener.
codes:.press . . followed by the door opener code.
The following will appear on the display:
LOCK.REL..CODE
The lock will be operated and the following message
will appear if the code is correct:
User
****
7