Volume Regulation; Display Contrast Regulation; Calls To Users; Calls.to.users.by.selecting.the.name - Urmet BiBus sinthesi s2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Minimum.PC.requirements.are:.
• 486.processor.or.higher.
• Windows 95 or 98 operating system
• Use.of.a.mouse.is.recommended..
The. signals. on. the. 9-pin. female. D-sub. connector.
are:.
Pin.1.. n.c.
Pin... RX.PC.data.
Pin.3.. TX.PC.data.
Pin.4.. n.c.
Pin.5.. Ground
Pin.6.. n.c.
Pin.7.. n.c.
Pin.8.. n.c.
Pin.9.. n.c.
Connect wire 1072/57 between module and PC
serial port to carry out the following operations:
1) Download data from PC (refer to the B-BUS
program. for. additional. information).. The.
following will appear on the module.
Data.reception
in.course...
The module will become operative again at the end
of.the.operation..
).. Upload.data.to.PC.(refer.to.the.B-BUS.program.
for additional information). The following will
appear.on.the.module:.
PLEASE
The module will become operative again at the end
of.the.operation..

VOLUME REGULATION

Volume. levels. are. calibrated. by. default. so. not.
to required adjustments in most cases. Use a
screwdriver to adjust the trimmers if required.
6
WAIT

DISPLAY CONTRAST REGULATION

The display contrast is set at the factory and will
not need to be adjusted in most installations. Use a
screwdriver to adjust the trimmers if required.

CALLS TO USERS

A.user.can.be.called.by.entering.the.user's.code.on.
the keypad. Obviously, the code must be known to
do. so.. The. name. can. be. sought. in. the. integrated.
electronic directory if the code is not known.
CALLS TO USERS BY SELECTING THE NAME
The following message will appear on the display:
Select.NAME
with
Press. .or. .to.scroll.the.user's.names.and.codes..
Hold. either. button. pressed. to. scroll. the. names.
faster.. Select. the. name. and. press.
selected user. The apartment door phone will ring
for. approximately. 3. seconds.. Hold.
send.up.to.three.consecutive.calls..
Name/code.display.example:.
URMET
1001
The following prompt will appear on the display if
is not pressed for longer than two seconds after
selecting.a.name:
To.call
press.
At.this.point,.either.press.
to.scroll.the.name.list..
The following will appear on the display when the
button.is.pressed:.
IN.COURSE
or.
. to. call. the.
. pressed. to.
.to.call.or.press. .or. .
CALL
DS107-035

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1072

Tabla de contenido