Wet Drilling - Chicago Pneumatic CP 0022 Instrucciones De Seguridad Y De Funcionamiento

Safety and operating instructions
Removing the drill steel
CP 0022 KL, CP 0032, CP 0069
Whenever removing the drill steel the following
instructions must be observed:
1. Push the retainer inwards in the direction of the
arrow until the drill steel collar disengages from
the front of the retainer.
2. Pull the drill steel out.
3. Push back the retainer.

Wet drilling

Before converting to wet drilling
Before converting the rock drill to wet drilling,
always switch off the air supply and bleed the
machine by depressing the throttle handle. Then
disconnect the air hose from the machine.
16
www.CrowderSupply.com • Toll Free: 888-883-5144
CP 0022, CP 0032, CP 0069
Converting to wet drilling
Only for CP 0032 and CP 0069
1. Unscrew plug (A) from the water connection.
2. Unscrew plug (B) from the back head.
3. Remove air tube (C) from the back head.
Only for CP 0032 and CP 0069
1. Assemble the water conversion kit (D) and
connect it to the water connection.
2. Screw in plug (E) into the back head.
3. Place water tube (F) into the back head.
9800 0901 90a | Original instructions