Eldes EKB3 Guia De Instalacion página 11

1st character for Configuration mode activation
and deactivation (for ESIM364 up to v02.06.20;
ESIM264 all versions) / 1st character for keypad
*
partition switch (if enabled; only for ESIM264) /
clear typed in characters
Typed in command confirmation
INDICATION
Steady ON
(red)
Flashing
Steady ON
(green)
Steady ON
(orange)
Flashing
Steady ON
(orange)
1-12
Steady ON
(red)
2. KEYPAD ADDRESS
ELDES alarm system supports up to 4 EKB3 keypads, each
individually addressed. The keypad address is set by physically
changing the jumper position on the pins located on the back
side of the keypad
JUMPER
COMBINATION
ADDRESS
Alternatively, the keypad address of the connected keypad can
be viewed using ELDES Configuration Tool software.
LED KEYPAD EKB3
DESCRIPTION
System armed / exit delay in
progress
Configuration mode activated
System is ready – no violated zones
and/or violated tampers exist
System faults exist
Violated high-numbered zone
Violated zone bypassed
Zone violated / configuration
command being typed in
3 2 1 3 2 1
Keypad Keypad
#1 #2
DESCRIPTION
3 2 1
Keypad
#3
EN
3 2 1
Keypad
#4
11