Avanti DGE 2403 SC Instrucciones De Operación página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WRONG
Fig. 2.4a
CORRECT
Fig. 2.4b
8
CHOICE OF BURNER
The symbols printed on the panel beside the gas knobs indicate the correspondence
between the knob and the burner.
The most suitable burner is to be chosen according to the diameter and volume capac-
ity of the container to be warmed.
It is important that the diameter of the pots or pans suitably match the heating poten-
tial of the burners in order not to jeopardise the efficiency of the burners, bringing about
a waste of gas fuel.
A small diameter pot or pan placed on a large burner does not necessarily mean that
boiling conditions are reached quicker.
Fig. 2.3
DIAMETERS OF PANS WHICH MAY BE USED ON THE HOB BURNERS
BURNER
Auxiliary
Semirapid
Triple-ring
CORRECT USE OF TRIPLE-RING BURNER
The flat-bottomed pans are to be placed directly onto the pan-support.
When using a WOK you need to place the supplied stand in the burner to avoid any
faulty operation of the triple-ring burner (Fig. 2.4a - 2.4b).
IMPORTANT:
The special grille for wok pans (fig. 2.4b) MUST BE PLACED ONLY over the pan-rest
for the triple-ring burner.
Make sure that the handles of cookware
do not stick out over the edge of the
cooker, to avoid them being knocked
over by accident. This also makes it
more difficult for children to reach the
cooking vessels.
(fig. 2.3)
MINIMUM
12 cm (4" 23/32 )
16 cm (6" 19/64)
26 cm (10" 15/64)
Wok pans max 36 cm (14" 11/64)
Do not use pans with concave or convex bases
MAX.
14 cm (5" 1/2)
24 cm (9" 7/16)
28 cm (11" 1/64)
(Fig. 2.4a - 2.4b)

Publicidad

Tabla de contenido
loading

Tabla de contenido