Metal Works DUAL START 3412 Manual De Instrucciones página 2

WARNING!
GB
Read entire manual carefully before operating the product!
To ensure the product a longer life and more effi cient, please note:
• Fully charge the battery when fi rst received.
• Fully charge the battery after each use.
• Fully charge the battery every 3 months.
Operational instructions
1. Jump starting
1.1 Turn ignition off before making cable connections.
1.2 Make sure the power switch is on the OFF position until clamps are connected to the vehicle battery.
1.3 Connect POSITIVE (RED) clamp to POSITIVE (POS, P, +) ungrounded post of battery.
1.4 Connect NEGATIVE (BLACK) clamp to vehicle chassis or engine block away from battery
1.5 If connecting the clamps backward, the reverse alarm LED will be on and an audio alarm will sound.
Do not turn your jump starter on! This could cause serious damage. Reverse the connections, and
the reverse alarm LED is off and the audio alarm will stop.
1.6 Dual Start 3412: Turn the power switch to the 12V position.
Dual Start 3424: Turn the power switch to the 12V or 24V position according to your car or truck.
1.7 Crank the engine for 3-5 seconds. If the engine does not start within 10 seconds, stop cranking and wait
at least 4 minutes before attempting to start the vehicle again. (This permits the battery to cool down.)
1.8 After the engine starts, turn the power switch to the OFF position. Then disconnect the NEGATIVE
(BLACK) clamp and then the POSITIVE (RED) clamp in that order.
1.9 Always return the cables to their stored position.
1.10 Recharge the jump starter as soon as possible after use.
2. Charging
Turn the power switch to charging (12V) position!
Plug the adaptor into the main supply and then insert the other end into the charge port on the front panel
of the jump starter. Continue charging until the charging status LED turns red to green.
After charged, turn the power switch to OFF position.
V1-28062011
829000110GBNLFE
829000120GBNLFE
post.