Metal Works DUAL START 3412 Manual De Instrucciones página 3

829000110GBNLFE
829000120GBNLFE
3. Checking internal battery status
Press on the TEST button; check the voltage of battery from the three indicating LED.
• HIGH LED means the jump starter is charged and ready to be used.
• MED LED means the jump starter needs to be charged as soon as possible.
• LOW LED means that the jump starter cannot be used and needs to be charged immediately.
4. Double 12V output sockets
If the jump starter is overloaded by output current (15A max), the circuit will be cut off automatically. Reduce output
power of electrical equipment and the circuit will be restored automatically in a few minutes.
Recharge the jump starter as soon as possible after using the output sockets.
5. Specifi cations
Voltage (DC Volts)
Cranking Amp
Peak Amp
Battery
Internal battery status display
Charging mode
Power outlet
Additional functions
12V
1200A
2400A
2 x 22 AH Lead-Acid
LED
Float charge
2 x 12 V
Overload protection
Polarity alarm
Metal case
TEST
CHARGING STATUS
REVERSE ALARM
DUAL START 3412 - Front panel
TEST
CHARGING STATUS
REVERSE ALARM
DUAL START 3424 - Front panel
Dual Start 3412
HIGH
MED
LOW
CHARGE PORT
12V
HIGH
OFF
MED
LOW
CHARGE PORT
Dual Start 3424
12V / 24V
1200A-12V, 600A-24V
2400A-12V, 1200A-24V
2 x 22 AH Lead-Acid
LED
Float charge
2 x 12 V
Overload protection
Polarity alarm
Metal case
OFF
V1-28062011