Breaking In The Pump; Overload Protector - Fini Advanced AIRBOSS Manual Del Usuario

ATTACHING HOSE
Insert the hose into the quick coupler already installed
on the compressor (Fig. 3).
WARNING:
Do not attach any tools to the open end of the hose until
start-up has been completed.
Firmly grasp the open end of the hose; hold facing
away from yourself and others.

BREAKING IN THE PUMP

See Figures 3 - 4.
Check and tighten all bolts, fittings, etc.
Turn the pressure regulator knob fully clockwise to
open the air flow.
Place the switch in the OFF (O) position and plug in the
power cord.
Open the drain valve completely.
Turn the air compress ON ( l ) and run the air
compressor for 10 minutes to break in pump parts.
Place the switch in the OFF (O) position.
Close the drain valve.
CAUTION:
Do Not operate compressor in vertical standing
position (Fig. 5B).
Safe Operating Position
Compressor must be operated laying flat as shown
in Fig. 5A.

OVERLOAD PROTECTOR

This air compressor is equipped with a thermal overload
device which will turn the air compressor off automatically,
if the air compressor becomes overheated. If the motor
turns OFF repeatedly, check for the following possible
causes first: Low Voltage from the outlet. Lack of proper
ventilation or outside air or room temperature too high.
Extension cord too long or wrong gauge wire used.
To reset the air compressor:
Turn the air compressor off.
Unplug the air compressor, and allow it to cool for 30
minutes.
Plug the air compressor into an approved outlet.
Turn the air compressor on.
ASSEMBLY
QUICK
COUPLER
Safe Operating Position
Fig. 5A
12
PRESSURE REGULATOR
REGULATOR PRESSURE
KNOB GAUGE
TANK
PRESSURE
GAUGE
DRAIN VALVE
Fig. 5B
ON/OFF
SWITCH
Fig. 3
Fig. 4