Pump Pressure - VITO PRO-POWER Manual De Instrucciones

EN
When the shaft is properly seated,
tighten the screw through the pipe.
Put a wheel on the axle and hold
using the provided nut (photo 7).
Repeat for the other wheel.
location
Before using the washing machine,
it must be prepared properly. Place
the washer on a firm location away
from buildings or other structures
ensuring that there are no blocks to
exhaustion.

PumP Pressure

The pressure pump is provided with
a lid to prevent spills. Remove the
cover and replace the valve (photo
8-8.1).
The pressure pump is provided with
a closed lubrication system, not
requiring additional lubrication.
PreParing the washer
to use
To prepare the washer, you must
follow the following steps:
Add oil to the crankcase.
Add fuel tank.
Connect the hose to the whole gun /
nozzle and pump.
Connecting water supply.
Connect the spray nozzle in accord-
ance with the work.
mount assemBly gun /
Ponteira / hose (Pic-
ture 9:10)
Before any work, make the mount-
ing of accessories.
Grab the end of the gun and tighten
the cap making sure that this is cor-
rect. Do not over tighten as this may
damage both connectors (photo 9).
Connect the pressure hose to the
connector on the other end of the
gun (photo 10-10.1) ensuring that
it is firmly tightened. Do not over
tighten as this may damage the
connectors.
gun saFety system
(Photo 11)
To avoid accidental operation, the
gun is equipped with a security
system (photo 11 - 11.1). To activate
this system, release the trigger and
the safety interlock between this
and the gun body.
25