VITO PRO-POWER Manual De Instrucciones página 29

EN
routine maintenance
(Pictured 12-13-29 to 30)
CANDLE (photo 29).
Each 50horas working sail must
be removed. Check the color of the
deposits at the end of the candle
must have a brown color. Clean the
deposits using a fine wire brush.
Check the slack in the sail (photo
29 - 29.1) and adjust if necessary.
The correct gap is between 0.7-
0.8mm.
rePlacement engine
oil (Photo 12 and 13):
Place the machine on a level sur-
face and warm the engine briefly.
Then turn off the engine.
Remove the cap (photo 12-12.1).
Place a water tray under the engine.
Remove the screw (photo 12-12.2)
for the oil to drain completely.
Should require a tube or similar, to
prevent leaking oil in the frame.
Check the screw, gaskets, oil cap
and O-ring.
Replace if necessary.
Put the screw again.
Add oil to the maximum level
indicated on the palette (Photo
13 - 13.1).
air Filter (Photo 30)
100horas after each use or every
month, the air filter (photo 30-30.1)
should be removed and see if it is
damaged or dirty. Clean the air filter
using a water-based detergent. Let
this dry completely.
warning:.Never run the engine
without the air filter installed.
Filter Fuel tanK (Photo
31)
150horas after each use, or
quarterly, the filter of the fuel tank
(photo 31-31.1) should be removed
and cleaned. Remove the cap of
the fuel tank and the filter, clean the
filter using a detergent based water
and reinsert
storage
If the engine is not used or is stored
for a long period (more than one
month), the following information
storage should be followed. Drain
the fuel tank and the carburetor
ensuring that all the fuel is removed.
Remove the spark plug and put
about a tablespoon of oil in the
hole. With the ignition OFF, pull the
starter rope several times. Place the
candle in your place and continue to
pull the starter rope until the point
of maximum compression (when
you feel too much resistance) and
after that you can stop.
Store the washer never dry and
well ventilated. Put it under a cover
to prevent accumulation of dust or
other debris.
PreParing For winter
and storage For long
Periods
If the washer is not used for a
period exceeding three months, or if
there is possibility of freezing during
the winter, the pump unit requires
protections to prevent damage. To
protect the pump unit, mix a solu-
tion of antifreeze car.
Place the liquid slowly off the pump
circuit. When the solution is drained
to the pump interior, this seal
with a cork or other seal element.
Continue adding antifreeze circuit at
the input of the pump until it is full,
then sealing it with a cork or similar
sealant.
When using the machine for the first
time after this period, make sure
that the antifreeze is totally removed
from the pump, hose and nozzle.
When using the machine for the first
time, you may notice small leaks
at the pump. These will disappear
after some time.
environmental
Protection
Information (private) on Waste
Electrical and Electronic Equipment
(WEEE).
This symbol on the product or on
the accompanying documents, in-
dicates that electrical or electronic
items used or damaged should not
be placed in household waste. For
treatment, recovery or recycling,
lightweight items to designated
collection points, where they will
be freely accepted. Alternatively,
in some countries, can deliver the
same to the dealer / importer after
29