Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions – SIM Card Installation / Cellular Gateway Quick Start Guide
INSTALLATION
N
ote:
This guide provides instructions for quickly installing
or switching SIM cards in your cellular gateway, and
provides instructions for getting your gateway regis-
tered for remote configuration.
AirLink RV50 Hardware User Guide
●
●
ALEOS
Software Configuration User Guide
®
●
●
Both are available for download from the Sierra Wireless
web site (source.sierrawireless.com).
STEP 1 Install the SIM Cards
N
ote:
Only applies to non-factory installed SIMs.
1.
Open the fixture door to get to the gateway.
2.
Use a #8 Phillips driver to remove gateway. (Figure 1.)
3.
Use a #1 Phillips screwdriver to remove the SIM card
cover. (Figure 2.)
4.
Slide the SIM cards into the SIM card slots until they
click into place. By default, the SIM card in slot 1 (the
upper slot) is the Primary SIM card. When the RV50 is
powered on or reboots, it automatically connects to the
network associated with the Primary SIM card. Later,
if you want to switch the device to another network
operator, you can use ACE manager to configure slot 2
to be the Primary SIM card slot. For more information,
refer to the ALEOS Software Configuration User Guide.
5.
Re-attach the cover.
6.
Ensure the connectors to the gateway remain tight
(Power, Antenna, and Ethernet).
7 .
Replace gateway with #8 Phillips screwdriver.
Figure 1.
2
EATON
IB512004EN
Installation instructions
STEP 2 Connect to AirLink Management Service
(Optional)
You can remotely configure and monitor all your gateways at
the same time with AirLink Management Service (ALMS),
Powered by AirVantage.
N
ote:
An ALMS account is required.
1.
Using a web browser, log into your ALMS account.
If you don't have an ALMS account,
visit www.sierrawireless.com/ALMS for information
on setting one up.
2.
If you have not already done so, register your gateways
by following the instructions on the registration page.
3.
Apply power to all your gateways. ALMS completes
the registration on power up. You are now ready to use
ALMS to configure your gateways.
SIM Card
1
2
SIM card slot 1
(upper)
Figure 2.
Reset
SIM card slot 2
(lower)
Publicidad
