Changing The Print Ribbon - Pyramid Technologies 4000 Manual De Instrucciones

not necessary to use all 28 punches or is it necessary to have 4 punches
per day. The only constraint is 28 punches per period.
Print format is as follows:
Clock in – Month, Day, Clock in time, "IN", Day of week
Clock out - Month, Day, Time, Clock in/out time total, Running
time total
SEMI-MONTHLY. 2 WEEKS, BI-WEEKLY AND MONTHLY- In these
modes the time card will accept up to 64 punches per period (2 per line, for
a total of 32 lines maximum). Print format is as follows (both clock in/out is
on same line of the time card):
Clock in – Day of week, Clock in time
Clock out - Clock out time, Clock in/out time total, running time total
1. Remove the cover using the key provided with the unit.
2. Locate the ribbon cartridge that is mounted on the holder (the holder is
permanently attached to the clock).
3. Push the hold tab located on the side of the holder away from the ribbon
cartridge and remove the ribbon cartridge.
4. Snap the new ribbon cartridge into the holder while turning the ribbon
advance knob located on the ribbon cartridge. Make sure the ribbon and
the clear plastic protector slide completely over the print head.
5. Replace and lock the cover. Test unit for proper installation by running a
time card through the unit.
Ribbon advance
knob

CHANGING THE PRINT RIBBON

10
Hold down tab