Programming; General Parameters - Favero Electronics 152-01 Manual De Instalacion Y Uso

ENGLISH
4.3. Selecting, starting and stopping a workout program
To select a "workout program":
press the [TIMER] key several times until the desired "workout program" is displayed ("t1",
•
"t2", ..., "t9"), and
• within 3 seconds press [STOP]
Press [START] and [STOP] to start and stop timing. You can program timing forward or backward.
4.4. Modifying the timer
With the timer stopped: press [#] and then change its value with [+] and [-] (keeping them pressed, the
change is rapid, only for the local keypad). At the end, press [#] again to confirm the changes or press
the other keys to delete the changes.

5. Programming

You can set the specific parameters of each of the nine (9) "workout programs" and the general
parameters valid for all the programs. Use the arrow keys [<] and [>] to scroll the parameters; you
can modify the values of these parameters with the keys [+] and [-] (on the local keypad, keep them
pressed to rapidly change the values).
"Fig. 5.1" shows the data displayed on the MT while programming.
Fig. 5.1 Data displayed on the MT while programming.

5.1. General parameters

To access the programming functions press [PROG]. Press [PROG] or [ON-OFF] again to quit the
programming mode.
Identifier Description
H1 Timing modes (dn: downward, uP: upward).
Sound type (trilling: 1, continuous: 2).
H2
H3 Sound volume (off: 0, low: 1, medium: 2, high: 3).
H4 PRE-WORKOUT duration (minutes:seconds).
H5 Regular sound emission interval - cadence (seconds).
1. Press [START] instead of [STOP] to start timing immediately.
8
/ 44
.
1
Parameter Value (minutes)
Parameter
00152-M01-ML - Multi Timer User Manual Rev01 - 151029 -
Value (seconds)
min
dn
1
0
0:00
0
Value
default max
uP uP
2 2
2 3
0:10 99:00
0 60
FAV E RO E L EC T RO NIC S