Wall Mounting; Getting Started & Installation; Programming - Pyramid Time Systems 5000+ Manual De Instrucciones

AUTO TOTALING TIME CLOCK INSTRUCTIONS
Model 5000 /5000
+
DESKTOP SET UP
1
Remove time clock from carton & place on a flat, level surface.
2
Plug unit into AC wall outlet.

WALL MOUNTING

1
Select a location convenient to employees
clocking IN & OUT. Be sure power outlet is
within 5 feet of mounting location.
2
Use masking tape to hold mounting template
on wall, making certain template is positioned
so bottom of time clock is approximately
45 inches from floor.
3
Drill holes using template as a guide.
4
Remove template from wall & install #10 screws,
leaving approximately 3/16 inch of screws
exposed. For sheetrock walls, use plastic
anchors.
5
Hang time clock on wall, aligning keyholes on the
rear with screw heads. Press downward on time
clock until it lowers onto screws. If mounting
5000+HD Time Clock, unlock & remove top/front
cover, & tighten wall screws to fasten.
6
Plug unit into AC wall outlet.

PROGRAMMING

1
Use key to unlock & remove top/front cover. Locate programming buttons
labeled SELECT,
2
Press SELECT until desired feature is displayed (see chart on page 5).
3
Press (UP) or t(DOWN) to scroll through feature options.
s
4
Press SELECT to save option setting & move to next feature.
4 INSTALLATION & PROGRAMMING
HD
+
s (UP) & t(DOWN).
Model 5000
+
Model 5000
+HD
888.479.7264