brondell SE400 Serie Manual Del Usuario página 7

SAFETY INFORMATION (cont.)
(IMPORTANT SAFEGUARDS)
GROUNDING AND GFI OUTLET INSTRUCTIONS
This product should only be used with a grounded GFCI
(Ground Fault Circuit Interrupter) outlet and a grounded
three-prong electrical cord as shown to the right. In the
event of an electrical short circuit, using a grounded GFCI
outlet reduces the risk of electric shock.
This product is equipped with a grounded cord and is for
use on a nominal 120V circuit only (minimum 15 amps) and
must be plugged into an outlet that is properly grounded
with a GFCI breaker as shown. Replace or repair a damaged
cord immediately.
Improper use of the grounding plug can result in a risk of electric shock.
• If repair or replacement of the cord or plug is necessary, do not connect the
grounding wire to either flat blade terminal. The wire with green insulation
(either with or without a yellow stripe) is the grounding wire.
• Check with a qualified electrician if the grounding instructions are not completely
understood, or if there is doubt if the product is properly grounded.
Extension Cord Use
If it is necessary to use an extension cord, only use those rated for a minimum of 15 amps with a
three-wire extension cord with a three-blade grounding plug. Only plug into a three-slot grounded
GFCI receptacle that will accept the plug of the product. Replace or repair any damaged cords
immediately.
SAVE THESE INSTRUCTIONS
Ground GFCI Outlet
Grounding Pin
Test
Reset
5