Table of Contents
Warranty ......................................................................... 3
What is Covered ........................................................................3
Pre-Installation .............................................................. 3
Tools Required...........................................................................3
Hardware Included ....................................................................3
Package Contents ......................................................................4
Safety Information
Always keep the user manual within reach while installing this LED
tape. Please read and understand the user manual to ensure proper
installation and use. Always pay attention to the technical data shown
on the product. We reserve the right to make technical changes.
Fitting and maintenance work may only be carried out by a
□
professional or an electrician in accordance with local safety
regulations.
□
All electrical connections must have good contact in order for
this product to have a long, useful life.
□ The LED chips of this LED tape cannot be replaced.
□ This LED tape includes a linkable connector. Only link a maximum
of one LED tape. Do not link multiple tapes together.
□ Choose a corresponding power supply for the LED tape.
□ Never use the unit in a room where there is a danger of explosion
or in the vicinity of ammable liquids or gases.
□ Do not bend, crush or pull the cable. Protect from sharp
edges, oil and heat.
□ Do not touch the LED strip or electrical connector directly
with hands.
□ For indoor only.
□ For any wire runs inside walls, use properly certi ed CL2 or
better wiring.
□ Ensure the connectors are securely fastened before operating
the tape.
□ Electrical waste should not be disposed of with household waste.
Please recycle where facilities exist.
□ All wiring must be in accordance with national and local electrical
codes, low voltage Class 2 circuit. If you are unclear as to how to
install and wire this product, contact a quali ed professional.
Installation................................................................... 8
FCC Statement...........................................................11
Service Parts ..............................................................11
DANGER: Danger of eye damage! Never look directly at the
LED chips of this LED tape.
CAUTION: Do not install Class 2 low voltage wiring in the
same runs as AC main power. If AC and low voltage wires
cross, keep them at 90-degree angles.
CAUTION: Do not install this product in areas that are
susceptible to direct exposure to the elements.
CAUTION: Do not power LED tape while coiled on reel.
IMPORTANT: Always observe polarity for 12V connections,
positive (+) to positive and negative (-) to negative.
IMPORTANT: Use only insulated staples, plastic ties, or
wire support clips to secure cords and wires.
NOTICE: LED lighting tape rating : 12V DC
2