Selecting The Input Signal - FUNAI F42PDME Manual Del Usuario

SELECTING THE INPUT SIGNAL

INPUT SELECT
DISPLAY
The procedure for selecting the input signal
described here is for use with the remote control.
However, the INPUT SELECT button on the plas-
ma display can also be used in the same way.
Displaying the Current Input Signal
1
Press the DISPLAY button.
The name of the current input terminal is dis-
played on the screen.
2
To clear the name of the current input terminal,
press the DISPLAY button again or wait for
approximately 4 seconds.
NOTE:
• To redisplay the name of the input terminal, press
the DISPLAY button again.
POWER
VOL
MUTE
SCREEN MODE
STILL
INPUT SELECT
DISPLAY
Selecting the Input Signal
1
Press the INPUT SELECT button to select the
input signal.
Each time you switch the input signal, the
name of the selected input terminal is dis-
played on the display for approximately 4 sec-
onds.
The INPUT SELECT button cycles through the
input terminals in the following pattern:
Video 1 Video 2
(S-Video 1) (S-Video 2)
Component 2
NOTE:
• When switching the input signal, audio mute turns
ON temporarily.
• S-VIDEO1 takes priority over the VIDEO 1 jack,
as does S-VIDEO 2 over the VIDEO 2 jack.
Therefore, if there is input to the VIDEO and S-
VIDEO terminals at the same time, the S-VIDEO
signal is displayed on the screen. If the S-VIDEO
cable is not connected to the plasma display, the
VIDEO signal will be displayed on the screen.
• 480i (interlaced) signals can be connected to the
COMPONENT 1 and 2 terminals. Any of the fol-
lowing display formats: 480i, 480p (progressive),
1080i and 720p (progressive) signals can be con-
nected to the COMPONENT 2 terminal. If one of
these video signals is detected, the format of the
input signal is displayed after the name of the
current input terminal, as in the following manner.
• A "No signal" message appears if there is no
video signal and there is no message currently
displayed on the screen for volume adjustment or
the setup menu, etc. If there continues to be no
video signal for more than 10 seconds, "No sig-
nal" slowly moves around the screen.
• If there is no video signal and there has been no
operation from the remote control or the buttons
on the main unit for more than 15 minutes, the
auto shut-off function activates and the display
switches to standby mode.
Component 1
9