Descargar Imprimir esta página

Changing The Aspect Ratio (Screen Mode) - FUNAI F42PDME Manual Del Usuario

Ocultar thumbs Ver también para F42PDME:

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING THE PLASMA DISPLAY

CHANGING THE ASPECT RATIO (SCREEN MODE)

SCREEN MODE
By changing the aspect ratio of the screen you
can select the manner in which you wish to view
the picture.
1
Press the SCREEN MODE button to display
the current screen mode.
2
Press the SCREEN MODE button a second
time to change the screen mode.
Mode
Normal
Full
Wide
Zoom
10
POWER
VOL
MUTE
SCREEN MODE
STILL
INPUT SELECT
DISPLAY
Picture
Normal
Full
Wide
Zoom
Each time you change the screen mode, the
name of the selected mode is displayed on the
screen for approximately 4 seconds.
The SCREEN MODE button switches between
the screen modes in the following pattern.
Normal
NOTE:
• When switching the input signal, the audio mute
turns ON temporarily.
• You can only select the "Normal" and "Zoom"
screen modes for 1080i and 720p video signals
connected to the COMPONENT 2 terminal.
Explanation
Normal will display a 4:3 picture at its standard 4:3
size. For 1080i and 720p video signals, a picture will
be displayed at 16:9 size.
Full will display a 4:3 picture at a 16:9 size, with
horizontal elongation necessary to fill the screen.
Wide will display a 4:3 picture at a 16:9 size, with less
horizontal elongation necessary to fill the screen
because a little bit of the top and bottom will be cut off.
Zoom will magnify the entire 4:3 picture to fill the
screen, with no horizontal elongation to fill the screen,
as more of the top and bottom are cut off. Use this
mode to view letterboxed 4:3 picture content to get a
widescreen picture. A 16:9 picture will be magnified
similarly, but to a lesser extent.
Full
Wide
Zoom

Publicidad

loading