Paramount MDX Manual Del Usuario página 11

SDX CONCRETE INSTALLATION
Concrete Ring Installation ( Fig. 6 )
Apply interior finishing material.
1.
Position the SDX Concrete Ring with the semi-circle
2.
tab located at the top and then press the ring into
finishing material.
Trowel the finishing material around outside and
3.
inside of the SDX Concrete Ring.
Form a watertight seal around the suction pipe.
4.
Wipe clean any finishing material that remains on
5.
the SDX Concrete Ring's top edge and mounting
surface.
Fig. 6
Fig. 7
Concrete Cover Assembly ( Fig. 7 )
Align the SDX Concrete Support with the alignment
1.
tab located on the SDX Concrete Ring.
Install three(3) machine screws through the SDX
2.
Concrete Support. Secure the screws without over
tightening.
Align the SDX Cover with the SDX Support holes.
3.
Install three(3) security screws through the SDX
4.
cover. Secure the screws without over tightening.
3" Min (typ)
9
( CONTINUED )