Content Check; Ups Positioning - GMP GM 360 PRO Manual Del Usario

C
ONTENT CHECK
It is first necessary to check the contents after the packaging has been opened:
steel slide, warranty card, instructions manuals, safety manual, inspection certificate, serial connection cable, keys for door lock.
UPS P
OSITIONING
When positioning, take into account that:
 the wheels are only to be used for accurate positioning, so for short trips
 plastic parts and the door are not able to act as pushing points or handles
 you will need to ensure at least enough free space in front of the equipment to allow for start/stop operations and
maintenance ( ≥ 1.5 m )
 the upper part should be at least 50cm from the ceiling to allow for maintenance operations
 the rear of the UPS must be placed at least 30 cm from the wall for proper air flow blown from air vents
 no objects should rest on the upper part of the UPS
After positioning, block the device by means of the front wheel brakes (see "Removing the pallet").
In earthquake zones or on mobile systems, it is possible to reuse the brackets for pallet fastening (slides) to anchor the UPS to
the floor (see figure below). These brackets are not necessary in normal conditions.
70