Terrain King KSB6 Manual Del Operador página 96

HYDRAULIC PUMP/OIL RESERVOIR
• Check oil reservoir level and oil condition. (Add
specific type oil if low)
• Change hydraulic oil filter and hydraulic oil
according to maintenance schedule.
• Ensure there are no oil leaks and fitting are
properly connected
• Inspect overall condition of hydraulic pump.
• Inspect pump drive shaft.
The oil reservoir has a filter condition gauge located on the filter housing. The filter will show in the red arc
when the oil filter needs changing or when the oil temperature is below 100 degrees F. The oil filter should be
changed after every 500 hours of operation or when the gauge shows in the red arc when the oil temperature
is above 100 degrees F. When changing the filter, also replace the breather filter element located under the
black cap. OPS-SB- 0005_A
Attention: Oil Filler Cap is also the Pressure Relief Cap.
Remove cap slowly to relieve pressure before removing cap completely. Stay clear to pre-
vent being scalded with hot oil that may spray out of the tank that is still pressurized and may
cause serious injury to eyes, face, and exposed skin.
Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and
hose connections. Relieve hydraulic pressure before performing maintenance or repairs.
Use gloves and eye protection when servicing hot components. Contact with a hot surface
or fluid can cause serious injury from burns or scalding.
KSB6 07/14
© 2014 Alamo Group Inc.
OPERATION
Operation Section 3-12
(Ops-0001-MISC)
(SG-34)