Rear Panel - Denon Professional DN-700AVP Guia Del Usuario

Rear Panel

17 17
11 11
13 13
12 12
1. Digital Inputs: Connect devices with coaxial and optical audio inputs here.
2. Network Connector: This connector is used to connect the unit to a LAN (local area network). The port is
used to stream audio from a media server or to connect to Internet radio.
3. Composite Video Inputs: Connect video outputs from a composite video device here.
4. HDMI Inputs: Use these 5 HDMI inputs to directly route the video and audio from a Blu-ray player or DVD
player to the HDMI output.
5. HDMI Out: Connect this HDMI output to a TV, projector, computer monitor, or DVR.
1
6. Analog Audio Inputs: Connect the audio output of your sound sources here.
7. Serial Port: This input lets you connect a host device (usually a computer) to DN-700AVP. You can use the
host device to control DN-700AVP via commands sent from it (using RS-232C serial communication).
8. Video Out (Composite): Connect this video output to the video input of another video source.
9. Video Inputs (Component): Connect the video inputs to the video output of another video source.
10. Video Outputs (Component): Connect the video outputs to the video input of another video source.
11. FM Tuner Antenna: Connect the included antenna here to get reception for FM radio sources.
12. CD In: Connect these balanced XLR inputs to the output of a preamp or mixer.
3
2
13. Input Level Setting Switch: Adjust this to switch the audio input level to -10 dBv or +4 dBu.
14. Balanced Outputs: Connect these individual surround channel XLR outputs to the input of a mixer or
preamp.
15. Balanced Output Level: Adjust this to switch the surround channel XLR output level to -10 dBv or +4 dBu.
16. Power Input: Connect the included power cable here.
17. Zone 2 Outputs: Sends the audio signal from the L/R and subwoofer output to another location.
18. 7.1 RCA Out: Use these coaxial outputs to send individual channels of the surround mix of the audio to a
speaker setup (75W per channel).
19. Bluetooth Antenna: The integrated antenna is used for Bluetooth reception.
20. Firmware Update: The "Service/Normal" switch is used to set the mode for the USB connection for the
firmware upgrade. For normal operation, this switch should be left in the Normal position.
4
5 4
6
1
14 14
18 18
5
7 8 9 10
14
3
20 20
7
2
19 19
8
4
11 12 13
16
15
9 10 10
15 15
16 16
17 18
6