Vacuum Operation; Maintenance - Black and Decker BV3100 Manual De Instrucciones

VaCuum operaTion

noTe: Ensure the vacuum is switched off
and disconnected from the power supply
before attaching or removing the vacuum
tube. The vacuum tube and collection bag
must be assembled to the housing before
use in vacuum mode.
• Position the vacuum tube slightly above
the debris/leaves. Turn the unit on, then
using a side to side sweeping motion the
debris/leaves will be sucked up the tube,
mulched and deposited into the collection
bag (figure H) .
CauTion: neVer remoVe THe
ColleCTion bag wiTHouT firsT Turning off and
unplugging THe VaCuum.
As the bag fills the power of the suction will decrease. To empty
collection bag, switch off the vacuum and and disconnect tool from
the power supply. Remove the collection bag from the power head,
unzip the collection bag to empty. Re-assemble before continuing to
operate.
wHaT To do if THe uniT jams: (figure i)
CauTion:
Turn off uniT and disConneCT Tool from
power supply.
If the unit motor stops, the fan has
become jammed. If this happens, turn
the unit off and disconnect from power
supply. Remove the bag and vacuum
tube. Remove the jamming material
using a small wooden stick. Do not use a
metal implement or anything, which may
damage the fan or scratch the plastic.
Ensure the fan will turn by hand before
reassembling the unit.
H
I
7
If the unit stops picking up debris or the performance substantially
reduces it may have become clogged. Switch the unit off and
disconnect from power supply. Remove the vacuum tube and look
down the tube to ensure no debris is blocking it. If necessary remove
debris with a small wooden stick. Do not use a metal implement or
anything, which may scratch or damage the tube. Remove the bag. If
the bag is full, empty the bag. If necessary remove any debris
from around the fan or unit outlet using a small wooden stick. Do
not use a metal implement or anything which may damage the
fan or scratch the plastic. Ensure the fan will turn by hand before
reassembling the unit.

mainTenanCe

Cleaning and sTorage
warning:
sHoCk Hazard. do noT pour or spray
waTer on THe Tool in an aTTempT To Clean.
CauTion:
Turn off uniT and disConneCT Tool from
power supply.
Use only mild soap and a damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the tool into a
liquid. Clean out any clippings which may have accumulated in the
Blower/Vac. When used properly with dry leaves the fan chamber of
your Blower/Vac should remain clean. If damp earth and debris are
ingested some of the particles may build up on the inside of the fan
chamber. If this happens the performance of the unit will decrease.
This area can be cleaned out using a wooden stick as shown in
figure i after disconnecting from the power source. Your Blower/Vac
should be stored in a dry place.
Do not store the tool on or adjacent to fertilizers or chemicals. Such
storage can cause rapid corrosion of the metal parts.