Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Laboratories (U.L.) (C.S.A. in Canada). If the extension will be used
outside, the cord must be suitable for outdoor use. Any cord marked as
outdoor can also be used for indoor work. An extension cord must have
adequate wire size (AWG or American Wire Gauge) for safety, and to
prevent loss of power and overheating. The smaller the gauge number
of the wire, the greater the capacity of the cable, that is 16 gauge has
more capacity than 18 gauge. When using more than one extension to
make up the total length, be sure each individual extension contains at
least the minimum wire size. Before using an extension cord, inspect it
for loose or exposed wires, damaged insulation, and defective fittings.
Make any needed repairs or replace the cord if necessary.
To determine the
Volts
minimum wire size
120V
required, refer to
ampere rating
the chart:
More Not more
Than Than
0
-
6
-
safety rules and instructions: polarized plug
To reduce the risk of electric shock, this equipment has a polarized plug
(one blade is wider than the other). This equipment must be used with a
suitable polarized 2 wire or 3 wire extension cord. Polarized connections will
fit together only one way. Make sure that the receptacle end of the extension
cord has large and small blade slot widths. If the plug does not fit fully into
the extension cord, reverse the plug. If it still does not fit, obtain a suitable
extension cord. If the extension cord does not fit fully into the outlet, contact
a qualified electrician to install the proper outlet. Do not change the tool plug
or extension cord in any way.
The label on your tool may include the following symbols.
V ............... volts
Hz ............. hertz
min ............ minutes
or DC...direct current
.............. double insulated
minimum gauge for Cord sets
Total length of Cord in feet
0-25
26-50
51-100 101-150
American Wire Gauge
6
18
16
16
10
18
16
14
A ....................amperes
W ...................watts
or AC .........alternating current
n o ...................no load speed
....................earthing terminal
............ safety alert symbol
............Read instruction manual before use
................Use proper respiratory protection
................Use proper eye protection
................Use proper hearing protection
14
12
1. Blower Tube Release Button
2. On / Off Switch
3. Blower Opening
4. Fan Cover
4
.../min or rpm...revolutions or
reciprocation per minute
ComponenTs
1
6
3
5
7
5. Blower Tube (2 pieces)
6. Vacuum Tube (2 pieces)
7. Collection Bag
2
4
Publicidad
Tabla de contenido
