Amprobe AT-6000 Manual De Uso página 17

3. MAIN APPLICATIONS - TRACING ENERGIZED AND DE-ENERGIZED WIRES
Using the AT-6000-R Receiver in Quick Scan Mode
Quick Scan mode detects wires at a longer distance (between a wire and the Receiver) but
with less precision than Precision Tracing or Breaker modes. This feature is used to verify that
the tracing signal is present and to quickly follow the path of the wire. Switch to Precision
Tracing mode to precisely pinpoint the wire, or to Breaker mode to locate a breaker.
1. Press ON/OFF push button to turn on the Receiver. It will automatically start in Quick
Scan mode, which is the default.
2. Scan a target area with the Tip Sensor to find a signal, then begin tracing the detected
wire. Increase or decrease sensitivity of the Receiver by pressing + or - on the keypad as
necessary.
3. For best results while tracing Energized wires, align groove on the Tip Sensor with wire
direction as shown in Figure 3.1c and Figure 3.1d. Signal may be not detected if not
properly aligned. To verify wire direction, periodically rotate the Receiver 90 degrees.
Signal strength will be the highest when wire is aligned with the Tip Sensor groove.
Depending on the detected signal, the Receiver automatically switches to either
Energized
manual setup is necessary.
Note: For best results, keep the Receiver at least 3 feet away from the Transmitter and test
leads to minimize signal interference.
NC V
Figure 3.1c: Signal not detected
or De-energized mode, and displays this information on the LCD. No
NC V
Figure 3.1d: Signal detected
13