Operation; Error Codes - Diehl Metering 548 Manual De Instalación

Deutsch
English
Information loop (3)
Sequence Window 1
3.1 Current date
3.2 "Sec_Adr"
3.3 "Pri_Adr 1"
3.4 "Pri_Adr 2"
3.5 "coldPIPE" * (installation location)
3.6 "Port 1"
3.7 "Port 2"
3.8 "UHF ON" (status of integrated radio)
3.9 Software version
Pulse loop (4)
Sequence Window 1
4.1 Pulse input 1
4.2 Pulse input 2
4.3 Pulse output 1
4.4 Pulse output 2
Tariff loop (5)
1
Month loop (6)
Sequence Window 1
6.1 "LOG"
6.2 "LOG"
: :
6.24 "LOG"
* Example Only for heat meters with activated cooling tariff
1
9.

Operation

Use the push button to page through the individual displays. When doing
so a differentiation is made between short and long button presses. With a
short button press (<3 seconds) you get to the next display within a loop;
with a long button press (>3 seconds) you get to the next display loop.
The "Energy" window (sequence 1.1) of the main loop is the basic display.
If the button is not pressed for approx. 4 minutes, the meter automatically
switches off the display to save power (exception: an error exists). If you
press the button again, the meter returns to the basic display.
10.

Error codes

If an error occurs, the error code is displayed in the main loop. All win-
dows, however, can still be accessed by pressing the button. If the button
is not pressed for approx. 4 minutes, the error code is automatically dis-
played again.
Français Español
Window 2
Cumulative value pulse input 1
Cumulative value pulse input 2
Pulse weighting pulse output 1
Pulse weighting pulse output 2
Window 2
Date
Date-1
:
Date
Window 2
Time
Secondary address
Primary address 1
Primary address 2
0* (no. of the plugged in module at
port 1)
1* (no. of the plugged in module at
port 2)
Check sum
Window 3
Pulse weighting
Pulse weighting
Window 3
Energy
Energy
:
Energy
Window 4
Max. flow
Max. flow
:
Max. flow
-33-