Marantz professional PMD-750TA Guia Del Usuario página 6

Setup
Items not listed under
Example 1 – Mono Operation
Mono operation will send the audio from one or two transmitters equally to the left and
right channels of the video soundtrack.
To send a mono signal to the camera while using one or two transmitters:
1. Connect your microphone to the mic input on the transmitter, and connect the
receiver's audio output to your camera's external mic input. Keep the volume
controls on the camera at its minimum settings.
2. If necessary, adjust the RFdB level on the transmitter to get a strong signal for
better operating range and noise resistance.
3. Turn on your camera, adjust the RX output level on the receiver and the input level
of the camera's external mic input to hear the audio signal (or view the level on the
input level of the camera).
4. In the audio recording settings on your camera, make sure it is set to Manual rather
than Auto. Check the input level meter, and adjust the level so that the loudest
sounds peak around -12 dB. Make sure the sound does not exceed 0 dB, which will
cause the signal to distort.
6
Introduction > Box Contents
Transmitter
are sold separately.
Receiver
Camera
Input
Mic