Airwell RC4 MURC4 Manual Del Usuario página 3

Idiomas disponibles

INSTRUCTIONS FOR THE REMOTE CONTROL

OPERATION OF THE PROGRAMMING FUNCTIONS

Four different types of programming function can be selected with the remote control. Two

daily programming functions (called T1 & T2) and two optional week-end programming functions

(called WKT1 & WKT2). Each of these programming functions can be selected by pressing

the TIMER key (10). To adjust the programs, use the HOUR + key (11) and HOUR - key (12).

The SET key (17) activates the programming function, and the CLEAR key (18) cancels it.

A. DAILY PROGRAMMING

Daily programming functions T1 and T2 enable the switch-on and switch-off times to be programmed

separately over two different periods. Once it has been set, the programming function will run every

day.

B. WEEK-END PROGRAMMING (OPTIONAL)

Week-end programming functions WKT1 and WKT2 enable the switch-on and switch-off to be

programmed separately over two different periods, for two days only.

These programs will operate on the specified day and following day, for two days only.

At midnight on the second day, the WK programming function stops and the daily programming

function resumes its normal operation.

WKT1 - Active on the specified day

WKT2 - Active on the day after the specified day

REMARK:

1. During the operation of the week-end programming functions, the daily programming functions are

deactivated.

2. The WK programming functions must be reactivated before each week-end.

C. CHOICE OF A PROGRAMMING FUNCTION

Press the TIMER key (10) to select a programming function. Each

time the TIMER key (10) is pressed, one of the four programming

icons shown below appears on the LCD display.

1 Press the TIMER key to select daily programming function T2.

Icon 2 of Programming function T2 flashes.

2 Press the TIMER key to select daily programming function T2.

Icon 2 of Programming function T2 flashes.

3 Press the TIMER key to select week-end programming function

WKT1.

Icons 1 and WK flash.

4 Press the TIMER key to select week-end programming function

WKT2.

Icons 2 and WK flash.