DOORGATE KTD6 600 N Manual De Instalación Y Programación página 19

Under normal conditions the power adjustment is automatic and no adjustments are necessary. It may, however a situation in
which the adjustment is necessary arise.
Press and hold SET, it displays P1.
Press UP once, it displays P2.
Press SET, it will show the corrent situation F5. Press UP to increase the force (maximum 9), press DOWN to
decrease the force (minimum 1).
Press SET to confirm, it displays standby mode (--).
At the end of the assembly should examine the strength of the door. Eg during the closing phase, to find an obstacle, you must
reverse the direction. If it does not, adjust the force down the scale 9-1 (previous point - ADJUSTMENTS) until the door to find it
and to reverse the direction.
This function is disabled at the factory. Make sure that the photocells are installed correctly before starting the program this
function.
Press SET, it displays P1.
Press UP twice, it displays P3.
Press SET it shows the corrent situation H0 (photo beam disabled) ou H1 (photo beam enabled). Press UP or
DOWN to select the desired mode.
Press SET to confirm and return to standby mode (--).
This function is disabled at the factory (b0).
Press and hold SET, it displays P1.
Press UP until appears on the display P4.
Press SET appears b0. Press UP or DOWN to select the desired pause time. For each pulse the UP or DOWN
add or subtract time from 1 minute to a maximum of 9 minutes.
Press SET to confirm and return to standby mode (--).
THIS IS THE MOST IMPORTANT SAFETY SYSTEM !
MAINTENANCE
There is no required maintenance in particular to the exchange.
Check at least twice a year if the door is properly balanced and if the moving parts are in good condition.
NOTE : A door that does not meet the requirements for automation may affect the life of automatism due to incorrect charges and
will void the respective warranty.
Check at least twice a year and sensitivity adjustments if necessary.
Make sure that the safety components are fully operational ( photocells , etc. . ) .
Force Adjustments
Photo Beam
Auto-close ON/OFF
P1
P2
F9
F1
--
P1
P3
H0
H1
--
P1
P4
b0
b9
--