Component Overview - Irritrol RainSensor RS1000-I Guia Del Usuario

Component Overview

Receiver (Figure 1)
1 - Weather-resistant Cover:
Slides upward to remove. Protects
the Receiver module when located
outdoors. Keep the cover installed
at all times other than when manu-
ally operating the Receiver.
2 - Antenna wire:
Straighten vertically for the best
reception.
3 - Sensor Status Indicator
Steady light - Sensor is active for
either rain or freeze.
Blinking light
Receiver has been bypassed for one
rain cycle. Smart Bypass button
pressed once. Press again to exit
bypass mode.
4 - Signal Indicator : Indicates the
quality of last received signal.
Steady light - good signal.
Blinking light - fair signal.
No light - poor signal (relocate
Sensor/Transmitter).
5 - Smart Bypass TM
Press to temporarily override the
sensor when active. Sensor opera-
tion will reset automatically. To manu-
ally exit the bypass mode, press but-
ton again.
6 - Power Indicator
Steady light - 24 V ac power is
connected.
Blinking light
tion problem.
No light - Unit is off or is disconnected from 24 V ac.
7 - Multi-wire Cable - 50 cm color-coded wires provided for controller connections.
Sensor/Transmitter (Figure 2)
1- Test Spindle - Press down and hold to manually test transmitter operation.
2 - Rainfall Adjustment Cap - Adjusts the Sensor/Transmitter to signal the Receiver
when the accumulated rainfall reaches 3 mm, 6 mm, 13 mm,19 mm or 26 mm.
3 - Universal Mounting Bracket with Quick-Clip
gutter, the side of a roof, a shed, fence etc. Sensor/Transmitter adjusts easily to the
vertical position.
4 - Antenna Wire - Straighten downward for maximum range.
:
- Indicates
Button :
:
- Sensor/Transmitter battery power low, or other communica-
Figure 1
1
Figure 2
1
2
4
TM - Simplifies installation on a rain
2
2
6
3
3
4
5
7