SLV Elektronik LHV60W24 Instructions De Montage página 3

LED Driver with constant output voltage for the operation of LED
(Switch-type electronic power supply unit)
MODEL: LHV60W24, LHV 100W24
1. Technical Data
Rated voltage
Constant output voltage
Shared Load Operation
Open circuit safety
Short circuit and overload
protection
Ambient temperature ta
Casing temperature tc-point
Thermal protection
EMC conformity
Primary main
Secondary main
2. Installation Instructions
The installation may only be carried out by an electrical specialist in accordance with international
and national standards.
LED Drivers are only intended for the use with LED that require a constant voltage of
24VDC.
When connecting the LED, careful attention should be paid to connecting + and – to the
right terminals on the LED Driver.
When working on electrical systems, the protection against electric shock is to be ensured by
disconnecting the system. Instal primary and secondary mains intersection-free (RFI protection).
LED Drivers mounted outside of luminaires are to be screwed tightly to the respective surface by
their screw holes and careful attention is to be paid to the primary and secondary lines being
fastened securely in the strain relief.
The tc temperature may not be exceeded for any kind of mounting. The devices do not contain
serviceable components and may not be opened.
3. Important Information
Our LED Drivers are surge voltage proof up to values far above those prescribed by the
respective standards. As a protection against high voltage surges, as they occur e.g. when
switching fluorescent lamps and discharge lamps with an inductive ballast, motors (fans, etc.) and
other inductive loads, the load circuits for devices of this kind are to be clearly separated from
each other.
!!The LED Driver cannot be regulated via a phase cut-on and a phase cut-off dimmer!!
K:\Dateien-HEP\Daten-HEP\Montageanl. deutsch, engl, span\Montageanl.5Sprachen\Montageanl. LHV60+100W24 d_e_f_s_nl.doc
Description and Mounting Instructions
Protection class 1
LHV60W24
Automatic cut-off through built-in temperature switch
EN 61547, EN 55015, EN 61000-3-2, EN 61000-3-3
CE
220-240V≈ 50-60Hz
24VDC SELV equivalent
1-60W
guaranteed
Electronic cut-off with automatic restart
Max. 50°C
Max.70°C
Min. H03VV-F 2x0,75mm² for strain relief
Min. H03VV-F 2x0,75mm² for strain relief
LHV100W24
1W-100W