Select Alarm 1 Relay Config - "A1C; Select Alarm 1 Relay Latching - "A1L; Select Alarm 1 Twa - "A1T - Macurco CD-6B Instrucciones Del Usuario

Macurco CD-6B Manual (Rev-1.0) Eng
6. Push Enter to confirm the new setting (display will stop flashing).
7. Push Enter once more to return to the configuration menu.
8. Push Next until "End" is displayed.
9. Push Enter to return to normal operation.
4.8.6 Select Alarm 1 Relay Config – "A1c"
Available options are "nO", "nC".
To select the Alarm 1 Relay Configuration, in normal mode:
1. Push the Next button to get to "Con" or the Configuration menu.
2. Push the Enter button to enter the Con menu.
3. Push Next 5 times to get to "A1c" or Alarm 1 Relay Configuration.
4. Push Enter. The display will show the current setting.
5. Push Next to cycle through the available settings (display will begin flashing).
6. Push Enter to confirm the new setting (display will stop flashing).
7. Push Enter once more to return to the configuration menu.
8. Push Next until "End" is displayed.
9. Push Enter to return to normal operation.
4.8.7 Select Alarm 1 Relay Latching – "A1L"
Available options are "OFF", "On".
To select the Alarm 1 Relay Latching configuration, in normal mode:
1. Push the Next button to get to "Con" or the Configuration menu.
2. Push the Enter button to enter the Con menu.
3. Push Next 6 times to get to "A1L" or Alarm 1 Relay Latching.
4. Push Enter. The display will show the current setting.
5. Push Next to cycle through the available settings (display will begin flashing).
6. Push Enter to confirm the new setting (display will stop flashing).
7. Push Enter once more to return to the configuration menu.
8. Push Next until "End" is displayed.
9. Push Enter to return to normal operation.
4.8.8 Select Alarm 1 tWa – "A1t"
Available options are "OFF", "On".
To select the Alarm 1 tWa, in normal mode:
1. Push the Next button to get to "Con" or the Configuration menu.
2. Push the Enter button to enter the Con menu.
3. Push Next 7 times to get to "A1t" or Alarm 1 tWa.
4. Push Enter. The display will show the current setting.
5. Push Next to cycle through the available settings (display will begin flashing).
6. Push Enter to confirm the new setting (display will stop flashing).
7. Push Enter once more to return to the configuration menu.
8. Push Next until "End" is displayed.
REV – 1.0 [34-2900-0510-2 ] 18 | P a g e