Grandstream UCM6510 Guía De Instalación Rápida página 4

CONNECTING THE UCM6510:
USB Port T1/E1/J1 Port
SD Card Slot 2 x FXS Port 2 x FXO Port
2 x DC 12V Power Jack
Basic connections for intial setup:
1. Connect one end of an RJ-45 Ethernet cable (cable type: straight through) into
the WAN port of the UCM6510; connect the other end into the uplink port of an
Ethernet switch/hub.
2. Connect the 12V DC power adapter into the DC 12V power jack 1 on the back of
the UCM6510. Insert the main plug of the power adapter into a surge-protected
power outlet. (Connect the second power adapter into the DC 12V power jack 2
for failover purpose in case the first one is down).
3. Wait for the UCM6510 to boot up. The LCD in the front will show its hardware
information when the bootup process is done.
4. Once the UCM6510 is successfully connected to the network, the LED indicator
for the WAN port in the front will be in solid green and the LCD shows up the IP
address.
Optional connections depending on how the UCM6510 is used:
1. PSTN Line Connection: connect PSTN lines from the wall jack to the UCM6510
LINE ports (FXO ports).
2. Analog Line Connection: connect analog lines (phone and fax) to the PHONE
ports (FXS ports).
3. T1/E1/J1 Line Connection: connect one end of the T1/E1/J1 cable provided from
the service provider into the T1/E1/J1 port of the UCM6510; connect the other
end into the T1/E1/J1 wall jack.
3
Navigation Keys
LED Indicators LCD
Ground
Reset LAN Port
WAN Port Heartbeat
Port
USING THE UCM6510 KEYPAD MENU:
1. Press "OK" key to start browsing menu options.
2. Press "Down" to browser different menu options. Press "OK" to select an entry.
3. In the menu option, select "Back" to go back to previous menu.
4. The LCD will return to default display after being idle in menu for longer than 20
seconds.
CONFIGURING THE UCM6510 VIA WEB GUI:
1. Connect the computer to the same network as the UCM6510.
2. Ensure the UCM6510 is properly powered up and shows its IP address in the
LCD.
3. Open a web browser in the computer and enter the IP address in the address
bar.
4. The web GUI login page will be shown as the figure below. The default user
name and password for administrator are "admin".
5. For the detailed information to configure SIP Extensions, PSTN lines, SIP trunks
and all the other system settings via web GUI, please download the UCM6510
user manual here:
http://www.grandstream.com/support
4