Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions - House Side Shield
INSTALLATION
Tools Required
•
#2 Phillips head screw driver and pliers.
House Side Shield (Figure 1. and Figure 2.)
1.
Remove plastic push pins on back side of optic.
(Figure 1.)
2.
Install house side shield with provided #10 x 1/2"
Phillips screws. Tighten until house side shield is snug.
Do not over tighten.
N
ote:
House side shield must ONLY be installed on the
back side of the optics as shown in (Figure 2.)
Front of Fixture
Figure 1.
Front of Fixture
Figure 2.
2
EATON
IB525001EN
Optic
Installation instructions
Plastic Pins
House Side Shield
Pole Side of Fixture
Screws #10 x 1/2"
Pole Side of Fixture
Publicidad
