QOOC Baby Food Maker Pro Manual De Usuario página 5

Reheating and Defrosting
1. The food to be reheated or defrosted should be placed in a suitable container, and then place
it in the cooking basket. If it is liquid, put a container bowl which can resist high temperature
and is smaller than the basket.
2.
Pour water according to the amount of food to be reheated and then operate according to the
cooking cycle instructions.
3. Rotate the dial clockwise. The indicator light is on and start to reheat/defrost food.
When the process is finished, the indicator lights turns off with a ding sound.
4.
Let the appliance cool down before open the lid and take out the food.
3.Cleaning
Danger
-
Do not place the appliance or accessories in water or any other liquid.
- Pour out any remaining water from the water reservoir, do not use the remaining water to
clean the appliance or the components.
- Never use bleach, chemical disinfection solution/ tablets, steel wool, grinding cleaning
agent or antiseptic liquid (e.g., gasoline, acetone or alcohol) to clean this appliance.
-
Never put the mixing jug handle into the boiling water or under hot water.
Caution
- Always unplug the appliance before cleaning it to avoid the risk of electric shock.
- Must be very careful when handling the mixing blade, the jug and accessories after cooking.
- Unplug the appliance after use, timely clean it and store it in a dry place.
- Never sterilize any components of this appliance with a sterilizer or microwave, it may
damage the appliance.
8
Thoroughly clean
1. Make sure to unplug the appliance before cleaning.
2. Remove the mixing jug and open mixing jug lid.
3. Hold the plastic part of the blade, rotate clockwise to disassemble the blade, always beware of
the sharp edge of the blade.
4. Thoroughly clean the tool, mixing blade holder, and rinse jug, jug lid, cooking basket and
spatula.
5. Clean the electrical base with a dry cloth.
6. After cleaning, place all the components in a ventilated and dry place, and open the reservoir lid
to prevent bacterial growth.
7. Rotate water reservoir lid counterclockwise and take it off from the water reservoir.
8. Rinse the lid under the faucet.
9. Pour water into the reservoir for cleaning when necessary. Repeat the process above as
needed until the water reservoir is clean. Please do not deposit any water in the water reservoir.
10. Dry the electric base and all the components after cleaning.
11. Assemble all the components after drying.
Releasing the mixing blade
Danger
- Be careful with the mixing blade(very sharp) and avoid cut.
1 Hold the plastic handle on the mixing
blade.
2 Clockwise rotating plastic handle to
disassemble the mixing blade component.
9