QOOC Baby Food Maker Pro Manual De Usuario página 7

7.Trouble—shooting
Question Solution
This appliance is equipped with
Out of
a safety lock. If components are
operation of
not properly assembled on the
the appliance
electric base, the appliance will
not work.
Appliance doesn't connected to
power.
Out of
Mixing jug doesn't installed on
operation of
the electric base properly.
the appliance
Cooking mode immediately
starts again right after the last
cooking.
Discoloration of
Natural pigments from the food
the contact parts
lead to discoloration.
with the food
There is no water in the water
reservoir.
No stream during
cooking
There is no water in the water
reservoir.
The water reservoir lid isn't
covered well.
Stream leakage The mixing jug isn't installed
of the water properly on the electric base.
reservoir during
The steam outlet of the water
cooking.
reservoir and the steam inlet of
the jug lid are clogged with dirt
or scale.
Ingredients are too big.
Ingredients are too much.
Water in the reservoir is too
Not thoroughly
little.
cooked
ingredients Cooking time is too short.
Too much scale in the reservoir.
All the components need to be
installed properly. Before cooking,
the mixing jug should be properly
installed on the electric base.
(Please refer to the "Use Methods"
of the manual for installation.)
Connect the appliance to power.
Install the mixing jug to the electric
base properly.
Stop using the appliance and let it
cool down for 8 minutes before you
use the cooking mode again.
It "s a normal phenomenon for
natural pigments. All contact parts
can still be used safely.
Stop using the appliance and
disconnect the power, then add
water to the reservoir.
Stop using the appliance and
disconnect the power, then add
water to the reservoir.
Cover the lid on the reservoir again
and confirm.
Install the mixing jug to the electric
base properly.
Clean the water reservoir and the
steam outlet on the jug lid.
Cut food into small pieces of 1.5cm.
Reduce the amount of food.
Add a proper amount of water
according to the cooking minutes.
Choose longer cooking time.
(Max: 25 mins)
Refer to "Descale" of the manual
to clean the water reservoir.
12
Question Solution
The steam inlet of the jug lid is
not aligned with the steam outlet
of the water reservoir.
Ingredients are too much.
The mixing jug isn't installed
properly on the electric base.
Out of operation
of the mixing
mode
Sticky food such as cheese is
put into the jug.
The mixing mode is on for more
than 30 seconds.
Loud noise, bad
Ingredients are too much.
smell and
overheated
appliance during The use of mixing mode is too
mixing long.
Blade seal is not installed or
installed well.
Leakage of the
mixing jug
Blade seal or the blade are
damaged.
Freezing food is too much.
Unsuccessful
defrosting of food
Freezing food is too sticky.
Install the mixing jug to the electric
base properly. (Please refer to the
"Use Methods" for installation.)
Stop the appliance and reduce the
amount of food. Total amount of
food should not exceed 250h.
Install the mixing jug to the electric
base properly. (Please refer to the
"Use Methods" for installation.)
Please refer to the warning of the
manual and use this appliance
correctly.
Stop mixing and cool the appliance
for several minutes, then start
mixing again.
Cut off power and reduce the
amount of food.
Each time of mixing should not
exceed 30 seconds.
Refer to the "Assembling of the
Mixing Blade" diagram of the
manual to install the blade correctly.
Replace new blade seal or blade
components.
The height of freezing food should
not exceed the mouth of the
cooking basket.
Stop and cool the appliance for 5
minutes, then defrost the food again.
13