Back Panel Connections - Chauvet VIP DRIVER Guía De Referencia Rápida

VIP™ Driver QRG
Back Panel
Connections
(cont.)
Number
D-Backup Out - is the secondary signal output and may be
configured as a backup or used to provide complete signal
7
reproduction at 1280 X 1024 pixels (each U-Main Out
D-Backup Out is 1280 x 512 pixels).
USB–Data In - connects to the content software for addressing
8
and calibration.
DVI-I Video In - connects to a video source. The DVI signal
9
must be a direct digital signal in. You cannot use an analog-to-
digital adaptor.
HDMI Video In - connects to a video source. The HDMI signal
10 must be a direct digital signal in. You cannot use an analog-to-
digital adaptor.
11 Power Switch - turns power on/off
12 Power In - IEC input 100 to 240 VAC, 50/60 Hz
LED Studio is provided free with the VIP™ Driver. The VIP™ Driver
enables media playback, configuration, addressing, and remote power
control from a rack-mounted VIP™ Media System. The VIP™ Driver
has two etherCON® signal outputs that connect to any type of VIP™
panel configuration.
The second signal output may be configured as a backup. The
D-Backup Out may also provide signal reproduction of the U-Main Out
at 1280 X 512 pixels.
Description
5
EN
and