Chauvet VIP DRIVER Guía De Referencia Rápida página 7

VIP™ Driver QRG
Backup Connection
Manually
Adjusting
Brightness
The VIP™ Driver provides two signal output connections: U-Main Out and
D-Backup Out. If the U-Main Out connection is broken, the D-Backup will
automatically kick in if the connection is used. Connect the VIP™ Signal
Distributor between the panels and U-Main Out connection.
U-Main to Video Wall
System connection
The Autolink function in the addressing software must be disabled for the
D-Backup Out connection to operate properly.
The front panel enables you to adjust the brightness of your video panels. By
default, the brightness defined in LED Studio is set to 1-16. You can edit the
brightness range in LED Studio, and then manually adjust it on the panel. Use
the <Up> and <Down> buttons on the front panel to manually override the
brightness setting defined in LED Studio. The brightness value will display on
the LED display.
Refer to the LED Studio User Manual for more information and instructions.
MVP™ Video Wall System
LED
Display
Down
7
Video Wall System to
D-Backup connection
Up
EN