ATIKA ASP 4 N Manual Original página 16

problem
Logs are not being split properly
(insufficient splitting performance)
Log ram travels out jerkily or under heavy
vibration
Log ram will not move out
Motor will not start
Oil leak at the dipstick
Model / Type
Year of construction
Splitting force
System pressure
Log length
Log diameter
Stroke
Piston rod diameter
Hydraulic oil (max.)
Electric motor performance
Power supply
Dimensions (Length x Width x Height)
Weight
Please observe the enclosed terms of guarantee.
16
P o s s i b l e p r o
P o s s i b l e p r o
possible cause
⇒ The log is not positioned correctly
⇒ The
log exceeds
dimensions or the wood is too hard for
the performance of the machine
⇒ The splitting wedge is not working
properly
⇒ Oil leak
⇒ Hydraulic pressure too low
⇒ Incorrect connecting lead (longer than
10 m or too small cable cross-section)
⇒ Air in the circuit
⇒ Hydraulic pump defective
⇒ No electrical power
⇒ Connection cable defective
⇒ Electric motor defective
⇒ Oil seal at the dipstick not sealing
T e c h n i c a l d
T e c h n i c a l
ASP 4 N
40 kN (4 t)
16 MPa
370 mm
max. 290 mm
2.5 litres
765 x 260 x 460 mm
approx.. 38 kg
G u a r a n t e
G u a r a n t e
b l e m s
b l e m s
remedy
⇒ Reposition the log correctly
⇒ Cut the log to the required dimensions
the maximum
⇒ Sharpen the splitting wedge, and check
for any burrs or notches
⇒ Place a sheet of cardboard under the log
splitter in order to locate the leak. To
correct the problem, refer to the
manufacturer.
⇒ Check the oil level and add more oil if
necessary.
If the problem cannot be rectified, refer to
the manufacturer.
⇒ Use the correct connecting lead
⇒ Open the bleed screw
⇒ Check the oil level and add more oil if
necessary.
If the problem cannot be rectified, refer to
the manufacturer.
⇒ To correct the problem, refer to the
manufacturer.
⇒ Check the fuse (10 A)
⇒ Replace the connection cable or have it
checked by an electrician.
⇒ To correct the problem, refer to the
manufacturer.
⇒ Replace the oil seal.
a t a
d a t a
see last page
50 - 250 mm
30 mm
P = 1500 W (S1)
1
230 V ~ 50 Hz
e
e
ASP 5 N
50 kN (5 t)
20 MPa
520 mm
max. 370 mm
3.0 litres
925 x 260 x 460 mm
approx.. 43 kg