Installation And Connection - Alto Professional AX2304 Guia Del Usuario

INSTALLATION AND CONNECTION

Read this section carefully. Not paying enough attention to the input signal's level, routing, or assignment of
can result in unwanted distortion, a corrupted signal or no sound at all.
Power Connection
Use the same fuse as marked on the fuse holder near the power jack. Connect AX2304 to a standard power
outlet using the enclosed power cable.
Audio Connection
AX2304 uses balanced XLR connectors. It can be connected to other units in a variety of ways to support a
vast range of applications without experiencing signal loss.
Wiring Configuration
XLR servo connectors can be wired in balanced and unbalanced modes. Please wire your systems
according to the following examples:
•
1/4" Phone jack
Tip
Sleeve
TS Type Unbalanced
•
XLR connector
Pin1
XLR Type Unbalanced
Ring
TRS Type Balanced
Pin2 (+)
Pin2 (+)
Pin3 (-) Pin3 (-)
(Linked to Pin1 manually
(Linked to Pin1 manually
Tip
Sleeve
Pin3 (-)
Pin3 (-)
XLR Type Balanced
4
Tip
Ring
Sleeve
TRS Type Unbalanced
Pin2 (+)
Pin1
Pin1