KRAUSE & BECKER 62915 Guia De Inicio Rapido página 2

Priming Spray Gun
Prime before first time operation and to flush storage fluids
1. Separate Tubes.
Hi Spray Low Spray Prime/Clean Roll
5. Pressure Control
Knob to prime/clean.
9. Turn power on.
*
Note:
For oil based paints flush with mineral spirits then warm water
For water based paints flush with warm water.
**
IMPORTANT:
If solvent will not flow through hoses,
try pressing the red inlet release button underneath the pump to loosen the inlet check ball.
Returns not accepted & warranty void
if sprayer is not properly cleaned
immediately after every use.
2. Priming Tube into
waste bucket.
6. Plug in and turn
power on.**
10. Spray into
waste bucket.
3. Suction Tube into
water or flushing
solvent.*
7. Wait 30-60 seconds
then power off.
11. Turn to spray while
spraying into bucket.
Clean sprayer immediately to
prevent permanent damage.
4. Turn to prime.
8. Suction Tube into
paint pail.
12. Tubes together
and into paint
pail then paint.