KRAUSE & BECKER 62915 Guia De Inicio Rapido página 4

Cleaning
Release sprayer pressure before cleaning
1. Drain paint
from Tubes.
5. Unthread spray tip.
9. Change to waste
bucket as paint thins.
13. Remove trigger
guard from housing.
Returns not accepted & warranty void
if sprayer is not properly cleaned
immediately after every use.
2. Separate Tubes.
6. Turn to spray.
10. Turn to prime.
14. Unscrew nut behind
swivel connector.
3. Priming Tube into
waste bucket.
7. Turn power on.
11. Continue to flush
until clear.
15. Remove filter.
Clean sprayer immediately to
prevent permanent damage.
4. Suction Tube
into water or
flushing fluid.
8. Spray paint into
paint pail.
12. Release pressure
then turn power off.
16. Clean all parts in
warm soapy water
or flushing fluid
using a bristle brush.