AMQ ACTIV-PRO Guia De Instalacion página 11

PHASE 6 | Worksurface Mounting
Step 1
To attach the worksurface, start by laying the
worksurface down on the floor with the top down.
Step 2
Lay the base assembly upside down on top of the
worksurface.
T - Type Cantilever
ST 5*20 x 18
for worksurface
ACTIV-PRO INSTALLATION GUIDE | 11
C - Type Cantilever
ST 5*20 x 16
for worksurface
Step 3
Double check to ensure that the base is properly
positioned on the underside of the worksurface,
and then attach with wood screws.
The worksurface should be center aligned
NOTE:
with the cantiliver depth and should have equal
amount of overhang on each end.`
Handset
ST 5*18 x 2
amqsolutions.com