Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pushbutton assembly
The pushbutton should be installed inside the
cold room store, in a visible place and no higher
than 125 cm from the floor.
AKO-520622
Secure it to the wall through the holes
designed for this purpose (A), connect it to the
device following the wiring diagram and close
the cover using the screws included (B).
A gland is included for cables with a Ø of 6 to
12 mm
Recommended installation
The cable must make a 180º bend after
exiting from the bottom of the button case (as
seen in image) to prevent water from reaching
cables.
7.- Wiring
Trapped person in cold room store pushbutton (Only AKO-15627 / AKO-15646)
AKO-15627
AKO-15646
PUSHBUTTON
B
B
1 2 3 4 5 6 7 8 9
P1 P2 P3
Max.
100 mts
Cable not
included
Bridge necessary
22
A
A
10 11
12
13
14
180º
15
16
17
18
+12Vcc
GND
Publicidad
Tabla de contenido
