Hayward ZPD Serie Manual De Instalación página 14

Alarms
Display
Fixed alarm LED
Flashing word "Lev"
Man
I.e.
Lev
Fixed alarm LED
Flashing words "Lev" and "stop"
I.e. Man
Lev Stop
Flashing word "Mem"
I.e. 1:n
Mem
Flashing word "Mem"
1:n M
I.e.
Mem
Fixed alarm LED
Flashing word "Flw"
I.e. Man F
Flw
I.e. Parameter Error
PROG to default
Hayward Flow Control
End of
interrupting pump operation
P100%
End of level alarm, with interruption
to pump operation
P100%
The pump receives one or more
pulses during dosage with memory
6
function on Off
The pump receives one or more
6 pulses during dosage with memory
function on On
Active flow alarm. The pump has
not received
number of signals from the flow
P100% sensor.
In Batch mode only: If Recovery
mode has been enabled, the F will
flash and the alarm will indicate that
the pump's flow sensor has not
detected the set maximum number
of signals.
Internal CPU communication error.
www.haywardflowcontrol.com
Cause
level alarm, without
the programmed
Interruption
Restore the liquid level.
Restore the liquid level.
Press the key
When the pump finishes receiving
external impulses, it returns the
memorized strokes
Press the key
Press the key to restore the
default parameters.
1-888-INDL (1-888-429-4635)
ZPDIOM
Pg. 12 of 12