Operation - Starting System - Hog Slat GROW-DISC HSCD200 Manual De Instalación Y Operación

GROW-DISK™ Feed System
Using the UP/DOWN arrow beside each number, adjust the HR. and MIN. for the time of day to start the
feed cycle. Depending upon 12Hr or 24Hr clock, the time will be shown. Once the hour and minute are
complete, press OK.
4. AM/PM: Press the AM/PM Select button to toggle between AM or PM. Be sure to review each
entry for correct AM/PM selection as the program defaults to AM after time entry.
5. DUMP:
Time.
6. RIGHT ARROW: Advances to TIMED FEEDING SCHEDULE 2 page to enter cycles 7-12 if
required.
9. OPERATION – STARTING SYSTEM:
After programming the settings is complete, the system is ready. Press any HOME button or Navigate
back to the MENU and then press HOME to return to the Status screen. MAKE SURE SYSTEM IS
COMPLETE AND READY TO OPERATE BEFORE STARTING UP TO PREVENT DAMAGE OR
INJURY. Make sure OPERATION MODE has been selected for Manual, Continuous or Timed Feeding.
When the system is not running and in STOPPED mode, the START button will be green.
Press the Start button to begin a feed cycle.
Hog Slat Inc. Newton Grove, NC USA
Time of day to activate the Feed Dump. Adjust time and AM/PM the same as Cycle
March 2019 REV A5
22